By HAN 
How to Draw a Beetle with this how-to video and step-by-step drawing instructions. Simple drawing for kids and beginners.
Please see the drawing tutorial in the video below
You can refer to the simple step-by-step drawing guide below
Step 1
Start by outlining the beetle’s head. Use curved lines to enclose irregular shapes. Notice the three bulges on the front of the head.
Step 2
Next, outline the thorax or midsection of the beetle. Use a long curved line to enclose the irregular shape.
Step 3
Use a long, curved line to enclose the irregularly shaped abdomen, leaving a small gap between the belly and the chest. Connect two body segments with short lines.
Step 4
Glue half-circles to the sides of the head to indicate the scarab’s eyes. Then contour each segment with curved lines at the edges. Also notice, the curve extends across the middle of the abdomen. This indicates a hole in the beetle’s shell that allows it to extend its wings.
Step 5
Draw the legs of the beetle. Extend a curved line and double it back onto itself to form the first leg section for each leg. Then stretch another curve and duplicate it back to itself. Finally, draw the beetle’s legs. Extend a curved line from the bottom of the leg. Then draw a jagged zigzag line to connect the opposite side to the leg. These serrations allow the beetle to grip and climb.
Step 6
Draw the pins of the opposite side. For each of the two leg sections, stretch a curved line and double it back to itself. For the feet, stretch a curved line. Then connect its tip to the leg using a serrated zigzag.
Step 7
Draw the jaws or latches of the beetle. For each one, extend a long, curved line from the front of the head. Then use a series of curved lines that meet at gentle or jagged points to form the inner face of the jaw axis.
Step 8
Draw the arches, appendages near the mouth that are used to touch and taste. For each palpation, extend a short curved line and double itself. Repeat this movement three times for each touch. Outline the jaw axes with curved lines.
Step 9
Draw beard. For each antenna, extend a pair of curved lines from the side of the tip. Connect them at the ends using a set of jagged lines.